Menü überspringen

工具測定

工具の機上計測(機内計測)を行うことにより、非生産時間を削減し、加工精度を向上させ、かつ不良品の削減とリワークを低減することができます。 ハイデンハインの接触式工具測長器TTシリーズと非接触式レーザー測長システムTLは、このような目的に最適な設計となっております。

TT touch probes

Probing method

Physical probing

Probing directions

3-dimensional: ±X, ±Y, +Z

Probing forces

Axial: 8 N, radial 1 N

Tool materials

Breakage-prone teeth are at risk

Sensitivity to
unclean tools

Very small

Possible measuring cycles

Length, radius, breakage, individual teeth

Installation effort

Simple connection to NC control

Signal transmission

Cable

Radio/infrared to SE 660; infrared to SE 642

Repeatability

2 σ ≤ 1 µm

Min. tool diameter

3 mm 1)

Model

undefinedTT 160

undefinedTT 460

TL laser system

Probing method

Non-contacting by laser beam

Probing directions

2-dimensional: ±X (or ±Y), +Z

Probing forces

No forces, operates without contact

Tool materials

Any

Sensitivity to unclean tools

High (tool must be cleaned with blown air before measurement)

Possible measuring cycles

Length, radius, breakage, individual teeth, tooth geometry (also for combined contours)

Installation effort

PLC adaptation in the NC control necessary (6 outputs, 3 inputs), compressed air connection

Signal transmission

Cable

Repeatability

2 σ ≤ 0.2 µm

2 σ ≤ 1 µm

Min. tool diameter

0.03 mm

0.1 mm

Max. tool diameter

37 mm 2)

30 mm 2)

80 mm 2)

180 mm 2)

Model

undefinedTL Nano

undefinedTL Micro 150

undefinedTL Micro 200

undefinedTL Micro 300

1) Probing force must not result in tool damage
2) With centered measurement